Tahiti

During one of our last days of our Pacific crossing Tucker and I sat in the cockpit remembering out loud each and every stop since we’ve been out cruising. Convivia sailed under the Golden Gate Bridge on October 1, 2011 and took a few weeks sailing down the coast of California. We spent five months in Mexico and in the spring of 2012 we began crossing the Pacific. We left Banderas Bay, Mexico on March 19th, 2012 and arrived in Bundaberg, Queensland, Australia on November 16, 2012. Since we left North America we spent 60 overnights at sea (I didn’t count the days or parts of days for those passages) and had 23 additional day sails. We zig-zagged north and south moving from colder to warmer and back until making landfall last Friday in Australia. ...

When I talk about our time in Papeete (Tahiti) I am inclined to describe it as all work and no play. When one is bogged down with projects like the Frankenfold (a.k.a the mainfold from hell), it is easy to forget that much fun has also been had. So before elaborating further on All The Fun® allow me to describe this particular bit of boat owner’s misery. Frankenfold Convivia has had numerous small fresh water leaks since we bought her. These have been dealt with more or less as they came up, and along the way I have even managed to improve on the system. On passage we started to develop a leak at the kitchen faucet, the location and disposition of which made it very difficult to fix. The short term solution was to decommission the faucet. Plumbing then took top priority on my project list. I had plenty of time to think about how best to address the situation. I wanted to remedy the existing problem and also make a substantial improvement to the overall stability of our ship’s pressurized water system. Ultimately this would have meant removing all of the hose and replacing it with Sea Tech hose. This being the middle of nowhere, I was not holding out of that. Plan B was to replace as many of the nylon fittings as I could and add a manifold as close to the pump as possible. After several (though it seemed like several hundred) trips to several hardware and marine stores, I was able to get all of the part together and complete the project. The result (as seen below) is not beautiful, but it works and solves a problem that would have been inevitable had I not taken the time. ...